Process pump for continuous tubing

Five tube materials to suit all applications

Five tube materials to suit all applications

Ultimate process security

Ultimate process security

Intuitive menu structure for rapid setup

Intuitive menu structure for rapid setup

Contact Us


To order this product please contact us on:

Tel: +353 (0) 21 4757030

You can also send us an email or find your nearest distributor.

Overview

730SN, 730UN, 730DuN and 730BpN peristaltic process pumps fitted with continuous tubing pumpheads

Control

Pump drives 730SN 730UN 730DuN 730BpN 730US 730DuS 730EnN
Manual control              
Intuitive keypad and color display
Choice of flowrate or speed display
Full calibration with choice of flow units
MemoDose function    
Auto restart facility
Guard switch detection
Leak detection
Remote control
   
   
Configurable Start/Stop, leak detector and pressure switch input via contact closure or 5V TTL or 24V industrial logic
   


Configurable Start/Stop, leak detector and pressure switch input via 110V industrial logic
 
 

Configurable Start/Stop and leak detector input via contact closure or 5V TTL or 24V industrial logic Note: Does not include pressure switch
 
 

Direction change and auto/manual toggle input via contact closure or 5V TTL or 24V industrial logic
   


Direction change and auto/manual toggle input via 110V industrial logic
 
 
Remote operation of MemDose (foot/hand-switch or logic input)
 
 


Four configurable digital status outputs through 24V, 30W relays
     


Four configurable digital status outputs through 110V relays
     
Remote pressure/flow sensors            
Analogue speed control              
Fully configurable inputs; 0-10V or 4-20mA
   
Analogue outputs; 0-10V, 4-20Ma      
Keypad/analogue input scaling (replacement of diaphragm pumps)          
Tacho frequency output; 0-1478Hz          
2x sensor inputs 4-20ma*            
Security              
3-level PIN lock
Network communication              
RS485 network control          
Digital pump commands (Profibus / EtherNet/IP)              
Profibus DP V0            
Communication speeds from 9.6kbit/s up to 12000kbit/s            
Baud Rate (MBPS) 10/100 Full/Half Duplex Operation              
Auto detect bus speed      
   
Speed set point          
Speed feedback          
Flow calibration function          
Hours run          
Revolution counter          
Leak detection          
Low fluid level alarm          
Diagnostic feedback          
EtherNet/IP      
   
Device Level Ring (DLR)            
Flow Totaliser      
   

Performance

    Tubing bore and flow rates (litre/hr)
  Speed (rpm) 9.6mm 12.7mm 15.9mm 19.0mm 25.4mm
720R 0.1-360
0.12-420 0.22-780 0.30-1100 0.42-1500 0.56-2000

Pumpheads

720R and 720RX continuous tubing pumpheads

Tubing is available in five materials for almost any chemical requirement.

 

720RE and 720REX LoadSure tubing element pumpheads

Elements are available in Pumpsil platinum-cured silicone, Bioprene and STA-PURE PCS for sanitary applications; and in Marprene, Pumpsil and Neoprene for industrial use.

Drives

Download datasheets

730 cover

Manual download

PROFIBUS

No point-to-point wiring and a simple 9-pin PROFIBUS D-connector provides:

PROFIBUSProfibus GSD control file

Tubing and hoses for your industry

  • Contact Us

    To order this product please contact us on:

    Tel: +353 (0) 21 4757030

    You can also send us an email or find your nearest distributor.